OPERATING INSTRUCTIONS
3-25
t
Table 3-11: Receiver Error Code Chart
4. SYNCRONIZING TRANSMITTER & RECEIVER:
NOTE
There are over 64,000 different addresses (id codes)
available for each transmitter and receiver pair. Each
transmitter and receiver pair is synchronized together at
the factory. If a new transmitter is needed, synchronizing
is required. Use the following procedure:
a. With the transmitter off, press and hold the
POWER button for >10 seconds until LED’s blink,
then release.
b. With power applied, press the red button on the
receiver for >5 seconds until LED’s toggle.
c. Wait for a few seconds until the green LED’s
begin to blink.
d. Teach complete.
Rear Impact Guard System
Vehicle standards FMVSS No. 224, Rear Impact
Protection, requires all 900C Series trailers manufactured
after January 26, 1998 shall be equipped with a rear
impact guard certified by the manufacturer as meeting
FMVSS No. 223, Rear Impact Guards. The guard, or
bumper,
, meets the following
requirements:
• minimum of 4 inches vertical height
• extend laterally to within 4 inches of the sides of the
trailer
• ground clearance of no more than 22 inches
• placed no more than 12 inches from the rear of the
trailer.
• capable to deflect 5 inches.
The standard also specifies minimum force and energy
absorption requirements for the guard. A DOT decal
certifies that the guard meets FMVSS No. 223 and 224
standards. The decal is placed
and must remain at all
times
on the forward facing surface of the guard, 12
inches inboard of the curb side and of the guard.
(See
Figure 3-14)
for location of decals.
Replace any component that does not allow the above
minimum requirements to be met. Any hardware that
holds the rear impact guard and becomes damaged or
becomes loose shall be removed and replaced. The 3/4”
grade 8 screws that hold the bumper energy pack shall
be loctited and torqued to 280 ft.-lbs.
DANGER
RECEIVER ERROR CODE CHART
ERROR CODE
PROBABLE CAUSE
1
RF COMMUNICATION PROBLEM
2
TILT DOWN FAULT
3
TILT UP FAULT
4
WINCH OUT FAULT
5
WINCH IN FAULT
6
AXLE BACK FAULT
7
AXLE AHEAD FAULT
Always check the condition of the rear impact
guard system. If guard system has been
damaged, it must be replaced. Failure to maintain
guard system may result in injury or death to
others.
Ea
st
ern
W
re
cke
r Sa
le
s
In
c
