Landoll 875-18, Operator'S Manual

Page: 53 / 64

4-3 ATTACHING TO THE TRACTOR
4-3.1 Align the tractor drawbar with the ma-
chine. Raise or lower the Tilloll ring hitch, as
needed, using the swivel jack. Attach the unit
with proper size hitch pin.
4-3.2 Clean all hydraulic couplings and attach
to the tractor. When properly attached, the
hydraulic control lever should cause the
Tilloll to:
a. Lower to the ground when the control arm is
moved forward or downward, and
b. Raise when the control arm is moved back-
ward or upward.
4-3.3 Fully extend the hydraulic gauge wheel
cylinders, and place the cylinder lockouts in
the transport lock position over the cylinder
rods. Secure the lockouts with the lockout
pins (See Figure 4-2).
4-3.4 Always place the swivel jack on the in-
terior mount before setting the machine in
motion.
4-3
Figure 4-2 Transport Locks