OPERATING INSTRUCTIONS
3-9
Pull Out Extensions
DANGER
CAUTION
1.
Pull out extensions are adjustable in six inch
increments. Extension lock pin can be held in
released position when pulled back and rotated one
quarter turn into catch.
2.
Adjust pull out to desired extended position and trip
lock pin to secure.
WARNING
3.
Additional blocking or planking may be used to
support load wheels/tracks
4.
Install the flag holders in the second hole of the front,
center, and rear overwidth tubes and secure with lock
washer and wing nut so the flag mounting tube is
pointing upward. Secure approved flags in the
mounting tube with the spring loaded retaining pin.
Reference FMCSR Part 393.87 and applicable state
and local regulations concerning flags on projecting
loads.
5.
If required, display oversize load signs.
Figure 3-5: Pull Out Extensions
DO NOT operate if any extension is not locked in
place by spring loaded locking pin. Inspect all
extensions to insure each is locked securely in
position by the spring loaded locking pin.
DO NOT pull extensions out of trailer frame
without adequate support. Failure do so may
cause injury.
1.
DO NOT overload extensions. overwidth
ratings are given in standard specifications.
2.
DO NOT secure load to overwidths or
undercarriage. secure load frame to mounted
d-rings or gotchas located in the approach
plate and frame beam flanges.
29(5:,'7+/2&.3,16
5,*+7+$1'(;7
+2/(6215,*+76,'(
/()7+$1'(;7
+2/(621/()76,'(
/2&.('
326,7,21
29(5:,'7+
)/$*+2/'(5
5(/($6('
326,7,21