Landoll 600A Series, Operator'S Manual, Page: 34 / 86

3-18 HYDRAULIC POWER SUPPLY ENGINE OPERATION (OPTIONAL)
3-18.1 The Hydraulic Power Supply Engine
system is used to power the hydraulic func-
tions, should the tractor not be equipped with
hydraulic hookups.
IMPORTANT
1. CHECK THE FOLLOWING FLUIDS BEFORE
STARTING THE ENGINE PACKAGE: ENGINE
OIL, FUEL SUPPLY, HYDRAULIC OIL. (CHECK
OIL LEVEL WHILE SEMITRAILER IS NOT
TILTED WILL CHANGE THE OIL LEVEL IN THE
TANK.)
2. IF THE ENGINE DOES NOT CRANK, CHECK
THE FOLLOWING ON THE BATTERY: CHARGE
FLUID, TERMINALS, AND CABLES. TAKE COR-
RECTIVE ACTIONS AS NEEDED.
CAUTION
IF THE HYDRAULIC FLUID LEVEL IS
LOW DURING OPERATION, THE SEMI-
TRAILER MAY NOT OPERATE COR-
RECTLY, RESULTING IN DAMAGE TO
THE SEMITRAILER.
3-18.2 The ENGINE IGNITION SWITCH is lo-
cated below the hydraulic controls, and
ahead of them on the driver’s side of the
semitrailer. Use the key to start and stop the
Hydraulic Power Supply Engine. (See Fig-
ure 3-10). This switch has three positions:
OFF In this position, the power package
engine does not run. The key can
only be inserted or removed from
this position.
RUN In this position, the engine runs with-
out activating the starter.
START In this position, the starter cranks the
power package engine, to start it. Af-
ter the engine is started, release the
key to the RUN position.
3-22
Figure 3-10 Engine Control Panel