Landoll 600A Series, Operator'S Manual

Page: 22 / 86

3-10 AXLE CONTROL LEVER
The AXLE CONTROL lever (See Figure 3-4)
is located on the control panel. It is the top lever
with three positions:
LOAD In this position, the undercarriage
slides forward for loading.
CENTER This is the neutral position.
TRANSPORT In this position, the undercarriage
slides to the rear. The undercarriage
must be in the rear-most position for
transport.
3-11 SWINGOUT OUTRIGGER PLATFORM EXTENSION SET-UP
(OPTIONAL)(See Figure 3-5)
3-11.1 Unlatch and fold out swing-out outrig-
gers.
3-11.2 Unlatch pull-out extension by pulling
spring loaded latch pin. Slide extension out
until it latches again.
3-11.3 Place planks on outriggers and assem-
ble end to end using braces, 3/8"-16 x 2-1/4"
bolts, washers, and nuts.
3-11.4 Plank joints must be centered on outrig-
gers.
3-11.5 To remove pull-out extension, reverse
steps 3-11.1 through 3-11.3b.
3-11.6 Remove only two bolts for each joint as
shown in Figure 3-5. Leave braces attached
to boards for storage.
3-10
Figure 3-5 Outrigger Platform Extension