Landoll 317D, Operator'S Manual, Page: 30 / 88

3-16 F-486-1011 Edition
OPERATING INSTRUCTIONS
Free Spool Clutch Operation (Braden)
1. The WINCH CLUTCH HANDLE (See Figures 3-8
and 3-9) is located on the right or curb-side end of
the winch assembly.
The function of the winch clutch handle is to engage
or disengage the winch, allowing it to respond to the
Winch Hydraulic lever.
Figure 3-8: 12,000# Winch Manual Clutch
Figure 3-9: 20,000# Winch Manual Clutch
Remote Control (Option)
IMPORTANT
On winches with the air tension option, the winch
tension is engaged automatically when the switch is
turned to winch in/out. The winch tension switch on
either the remote or the control panel must be used
to disengage the winch.
1. A wireless six function radio remote control is
available
(See Figure 3-10.)
2. The wireless radio remote has six momentary push
button switches that operate the functions as labeled
on the hand held remote.
3. Specifications:
RF: 902-928 MHz FHSS 10mW
Temperature: Receiver: -40
o
to +85
o
C
Transmitter: -20
o
to +60
o
C
Output Rating: 5 Amps each (sourcing)
20 Amp system maximum
Encapsulated electronics inside receiver.
Transmitter IP-66
Power: 3.7V LiPo battery
Battery Life: 30 - 40 hours continuous
DISENGAGE When the handle is placed in this
position, the winch is disengaged. This
allows the spool to “free-wheel” and the
winch is not affected by use of the
Winch Hydraulic lever.
ENGAGE When the handle is placed in this
position, the winch is engaged and
cable may be spooled on or off the
winch spool. The winch can now be
controlled through the use of the Winch
Hydraulic lever.
ENGAGE
DISENGAGE
PULL
clutch12
ENGAGE DISENGAGE
clutch20