Landoll 1230 Series, Operator'S Manual

Page: 35 / 64

3-20 ELECTRICAL INSTALLATION
3-20.1 Assemble right and left hand warning
lights to the warning light brackets using
1/4-20 x 1-1/4 hex head cap screws and hex
lock nuts. Insure the wires are in the groove
in the base of the light toward the mounting
surface of the bracket. Assemble one light
for left side and one for right side. The red
light should be to the rear with the amber
light being the outer most light (See Figure
3-46).
3-18.2 Assemble the light and bracket assembly
to the angle bracket (side with only two
holes) using 1/2-13 x 1-1/2 hex head cap
screws and hex lock nuts.
3-20.2 Install the assembled lights on the outside
of the frame just forward of the rear hinge
using bar and 1/2-13 x 5-1/2 hex head cap
screws and hex lock nuts.
IMPORTANT
MAKE SURE LIGHTS ARE POSITIONED FOR
MAXIMUM VISIBILITY FROM THE REAR.
3-20.3 Install the rear wiring harness between the
lights.
3-20.4 Install the main harness by starting at the
hitch and routing the harness along the
frame to the rear harness.
3-20.5 Insure the harnesses are clear of any
moving parts and secure the harnesses with
tie wraps provided.
3-23
Figure 3-46 Electrical Installation