Landoll 1230 Series, Operator'S Manual

Page: 24 / 64

3-18 GAUGE WHEELS
3-18.1 Locate gauge wheels on outer end of cut-
ter wing frames as shown in assembly lay-
out.
3-18.2 Attach one long plate and one short plate
to wing frame with four 5/8" x 7" cap screws,
lock washers, nuts (See Figure 3-26) .
3-18.3 Attach another long plate to assembly us-
ing four 5/8" x 3" cap screws with four spac-
ers, lock washers, nuts.
3-18.4 Insert wheel support between plates. Use
L-pin and clip pin to hold in place.
3-18.5 Install wheel on hub.Tighten wheel bolts to
80 ft-lb (108 N ⋅ m).
3-18.6 Using wheel height adjustment lever, re-
move L-pin and lower gauge wheel to
ground to support wing frame. Replace L-pin
and clip pin. Return adjustment lever to stor-
age position (See Figure 3-27) .
3-12
Figure 3-26 - Gauge Wheel Support Figure 3-27 - Gauge Wheel on RH Wing