NSQ412 Four-Line Caller ID Telephone Owner’s Manual 19
To make an outgoing call handsfree,
press the [SPEAKER] key. Any idle CO
Line will automatically be connected. The
CO Line selected will depend upon the
Line Preference set in programming
mode and if there are lines in use. Dial
the phone number and the LCD displays
the digits one by one. The time begins to
count. The LCD will display the same as
when making an outgoing call with the
handset (see previous examples).
To make an outgoing call using a headset
(corded or wireless), press the [HEAD-
SET] key. An idle CO Line will automati-
cally be connected. The CO Line select-
ed will depend upon the Line Preference
set in programming mode and if there are
lines in use.
NOTE:
When using the Plantronics
CS50-R Wireless Headset, please
refer to the CS50-R Owner’s Manual
for complete operation instruction.
NOTE:
Pressing the [HEADSET] key
without a headset plugged in will result
in a double beep warning (the headset
mode will not activate). Dial the phone
number and the LCD displays the digits
one by one. The timer begins to count.
The LCD will display the same as when
making an outgoing call with the handset
(see previous examples).
NOTE:
If both the corded headset and the
CS50-R wireless headset base are
plugged in, the default is the corded head-
set.
NOTE:
The unit will always dial Tone
numbers unless the dial mode is changed
to Pulse in programming.
Switching Between Handset,
Handsfree and Headset
The telephone will allow switching
between the handset, handsfree and
headset modes. To switch from the
handset to handsfree, press the
[SPEAKER] key. The Speaker LED
will light. The handset may be placed
in the cradle, but does not have to be.
To switch from handset to headset (corded
or wireless), press the [HEADSET] key. The
Headset LED will light. THe handset may be
placed in the cradle, but does not have to be.
NOTE:
If both the corded headset and
the CS50-R wireless headset base are
plugged in, the default is the corded
headset.
To switch back to handset when it is in the
cradle, lift the handset. The handsfree or
headset or headset will be disabled. To
switch back to the handset when it is out
of the cradle, press the [SPEAKER] key
(if in handsfree mode) or the [HEADSET]
key (if the headset mode). The handsfree
of headset will disable.
NOTE:
When the phone is on-hook
and idle, pressing a [CO LINE] key
will activate the previous talking mode
(handsfree or headset). The default
is handsfree mode.
Call Timer Operation
The timer will automatically start to count
when a CO Line is picked up. It will stop
counting automatically when the CO Line
is hung up. The LCD will continue to
display the time for approximately
10-seconds afterwards. The LCD will
display the elapsed time in minutes
and seconds for the first hour (up to 59
minutes and 59 seconds), then begin
counting again at 00:00. The timer will
start over whenever the CO Line status
is changed (such as placed on hold, or
flash activated, etc).
