Landmann Triton PTS 2.0 12901, Assembly And Operating Manual

Page: 10 / 24

10
Triton PTS 2.0
Igniting the burners
Danger: gas deflagration upon ignition
If unburned gas accumulates, deflagration can
occur when igniting.
Possible consequences:
• This can cause severe injury or damage.
Precautions:
• Do not lean over the barbecue when igniting
the gas flame.
• Never re-ignite immediately if the flame goes
out, instead:
– Turn the flame regulators (2 x B) to "Off" to
interrupt the supply of gas.
– Wait for 3 minutes to ensure that any
accumulated gas has dissipated.
– Then re-ignite the burners.
1. Open the lid on the grill unit.
Maintain the greatest possible distance from the
grill unit during the next few steps.
2. Press and turn the respective flame regulator (B) in
anti-clockwise direction to HIGH ("large flame").
Keep it pressed in this position. In this process,
you will hear a cracking noise caused by the Piezo
ignition and the burner ignites.
3. Ignite the other burner on the grill unit. When
doing this repeat steps 2 and 3.
4. Close the lid of the grill unit and allow the
barbecue to heat up at full power.
The first time you use the barbecue, heat for some
20 minutes without food so that the food-safe
coating is hardened (as with any oven).
Once the barbecue is heated up, turn the flame
regulator (B) to the desired heat level (flame size).
7. You can now place your food on the grill. We
recommend that you wear barbecue mittens or
other suitable gloves for protection against the
heat.
To switch off the burners (to extinguish the flame)
press and turn the flame regulators (B) clockwise to
"OFF".
The gas supply is only disconnected if all the flame
regulators have been set to OFF.
Igniting the burner on the grill unit
Operation
Starting up the barbecue
1. Check to ensure that ....
– there are not, and will not be, any flammable
materials or substances nearby. Minimum
distance to flammable materials or substances:
2 m overhead and 1 m to the side; distance to
flame-resistant materials or substances: at least
0.25 m.
– the barbecue is positioned firmly on a
sufficiently large area. Do not move it during
operation.
– the barbecue is fully assembled and has no
apparent faults.
2. Open the lid of the grill unit; this prevents gas
building up underneath it.
3. Open the cylinder valve (turn G1 anti-clockwise).
4. Check to ensure that the gas system does not leak.
If it does, close the cylinder valve immediately
(turn G1 in clockwise direction).
5. Insert the grease tray (23) into shelf of the grill
unit (10).
Caution:
Observe the maximum load of the shelves (see
Technical Data). Heavier loads can damage the
barbecue.
23
24
+
10
13.