Landmann Avalon PTS Plus 5.1 Plus 12122, Assembly And Operating Manual

Page: 13 / 32

13 Avalon PTS+ 5.1+
Troubleshooting
If there is a fault despite due care, this chapter may help you to resolve the fault.
Fault Potential cause Remedy
There is a smell of gas Leak in the gas system 1. Close the cylinder valve imme-
diately.
2. Prevent any flame or spark for-
mation (do not switch on any
electrical appliances)
3. Tighten all connections on the
gas system
4. Check all components of the
gas system for visible damage;
replace defective parts with ori-
ginal spare parts
5. Check for leaks using a leak
detector
Burner does not ignite Gas cylinder is empty Replace the gas cylinder
Cylinder valve is closed Open the cylinder valve.
The nozzle on the adjusting ele-
ment (behind front panel) is not
inserted into the burner hose.
Visual test, if necessary adjust noz-
zle and connection hose.
The igniter cable is not connected
to the Piezo igniter
Conduct a visual test, connect if
necessary
Distance between the spark plug
and gas outlets on the burner is
incorrect
Visual inspection; correct if neces-
sary
Nozzle on adjusting element
(underneath front panel) is
blocked.
Clean the adjuster jet with a need-
le
Other gas system blocked The gas system should be cleaned
by a specialist
Barbecue temperature too low Pre-heating time too short Grill unit coverClose the lid and set
the flame regulator to max
Gas outlets on the burner are
blocked
Remove blockage from burner
Strong flare-up Fatty foods Remove any large areas of fat pri-
or to barbecuing or place the meat
on a grill plate or reduce the bar-
becue temperature
Deflagration or bubbling noise Flashback caused by blockages in
the burner.
1. Close the cylinder valve imme-
diately.
2. Wait three minutes and then
switch the barbecue back on
3. If the malfunction reoccurs,
disassemble and clean the bur-
ner