Landmann Avalon PTS Plus 3.1 12121, Assembly And Operating Manual, Page: 11 / 32

11
Avalon PTS+ 3.1
Switching off the barbecue
1. Close the cylinder valve on the gas cylinder.
2. Press and turn all flame regulators (B+C) clockwise
to "OFF".
3. Wait until all of the parts have cooled down and
then clean any soiled components (see chapter
"Cleaning").
4. Close the lid on the grill unit.
5. If the barbecue is not going to be used for a pro-
longed period:
– Disconnect the gas cylinder (see chapter "Dis-
connecting the gas cylinder").
– Store the barbecue in a dry place.
Cleaning
Barbecue
Danger: Risk of burns when cleaning the
hot barbecue
Some parts of the barbecue can get very hot.
Allow the barbecue to cool down sufficiently
before cleaning it. Wear protective gloves.
Caution: Spark plug on burner can be
bent
The spark plugs on the burner can be bent or
snapped off while cleaning the burner areas. In
this case, the gas in the burner will not ignite. For
this reason, clean the areas around the burners
with particular care.
To make sure that you enjoy your barbecue for many
years, you should always clean it after use – after
making sure that all the parts have cooled down –
with detergent, a brush and a cloth. It will be much
harder to do this later, once the dirt has dried.
Gas system
The gas outlet nozzles on the adjusters (underneath
the front panel) can be cleaned with a pin if neces-
sary.
Warning: Risk of fire and explosion
All other parts through which gas is transferred
should only be cleaned by an expert.
Never dismantle the adjusting elements!
Igniting the side burner
Caution:
• Please note that a gas flame is often difficult
to see due to its blue colouring, particularly in
bright sunlight. For this reason:
– Only ignite the side burner when you need
it and place your cookware on the burner
straight away.
– Disconnect the gas supply before removing
your cookware.
• Use 260mm cookware on the side burner that
has been approved for use on gas cooking
appliances. Cookware that is unsuitable for
gas appliances may be damaged.
• Observe the maximum load capacity of the
side burner (see "Specifications"). Heavier
loads can damage the barbecue.
1. Open the side burner cover.
2. Check that the side burner support (24) have been
securely positioned.
You must not use the side burner without the side
burner support.
3. Press and hold the ignition button of the pulse
ignition (D). A slight crackling sound indicates that
the electronic pulse igniter is emitting sparks. Press
a flame regulator (C) and turn it anti-clockwise to
the "H" ("High") setting.
If the gas fails to ignite within 5 seconds, turn the
flame regulator (C) to "Off" position, wait for 3
minutes and repeat this step.
4. Turn the flame regulator (C) to the desired heat
setting (flame size), place a pot or pan that is
approved for gas cooking appliances on the side
burner and heat up your food.
To switch off the side burner (extinguish the flame)
press and turn the flame regulator (C) clockwise to
"OFF".