Installation Manual
Generation II Harley
Cush Drive Mount Rev II
Copyright 2016, Pete Giarrusso, Inc.
D/B/A Chopper Design Services
All Rights Reserved
Page 1: ...Installation Manual Generation II Harley Cush Drive Mount Rev II Copyright 2016 Pete Giarrusso Inc D B A Chopper Design Services All Rights Reserved ...
Page 2: ...spin it to test the sensor and its placement Make sure the bike is in neutral Remove the bottom bolt from the right shock at the rear of the bike Insert the top of the bracket shown at left behind the shock and in front of the hole in the swing arm so the bolt will pass though it when reinserted NOTE the yellow sensor seen here will be close to the brake rotor and below the shock bolt see below Re...
Page 3: ...as described above Once you are certain tighten the shock bolt and test it again Rotate the wheel past all 5 spokes on the brake rotor and make sure the light blinks and goes out each time If all is perfect you are done The automatic retraction of the legs as well as their deployment RELIES on this sensor being placed perfectly Now we can route the wire Reroute the wire on the top of the swingarm ...
