Installation
23
Figure 2-6. Secure Console with Ratchet Strap
4. Tighten the strap to secure it and prevent the treadmill
console from moving. Do not overtighten.
5. Unplug the wiring harness running up the treadmill’s right
upright by pushing in the locking tab, then disconnecting
the connector (Figure 2-7).
Figure 2-7. Unplug Wiring Harness
6. Locate the three upright pivot bolts on one side (Figure 2-
8). Remove the bolts and associated nylon nuts using an
M8 hex wrench (supplied) or M8 hex socket. Repeat on the
other treadmill upright. Set bolts and nuts aside for
reassembly.