Troubleshooting
PT4: Calibration in Progress Message at Start Up
62
6.21. PT4: Calibration in Progress Message at Start Up
PT4 90 Series Treadmill reads Calibration in Progress at Start Up
NO
YES
Engage the safety key
into the mini pod.
Use this flow chart if this error message do
esn’t
go away after 5 seconds of being powered on.
Turn the treadmill off at the ON / OFF power switch located at
the motor pan. Check to see if the safety key is engaged in the
mini pod.
WAS THE SAFETY KEY ENGAGED IN THE MINI POD?
YES
Pull and reengage the safety key on the mini pod
making sure it is fully secure in place.
Power the treadmill back on at the switch.
IS THE ERROR CODE STILL PRESENT?
NO
Press
STAR
T on the
treadmill.
If error code is still present after 10 seconds
replace the mini pod on the treadmill.
(P/N: 75020)
YES
Problem solved.
NO
Summary of Contents for L7 Club
