Installation
36
22. Remove the four cross-head 8-32X1 screws from the frame
(Figure 2-17). Tilt the motor cover between the uprights and
place over motor pan. Install the motor cover using cross-
head screws above.
Figure 2-17. Motor Cover Screw Locations
23. Plug the treadmill power cord into a dedicated power outlet.
Ensure that the power cord has plenty of slack and will not
be pinched beneath the treadmill as the treadmill elevates
up and down.
24. Turn on the power switch located next to the power cord
and make sure the safety lanyard block is pushed in. Start
the treadmill and increase speed to 2 mph. Check that the
tread belt is tracked (centered) and not moving off to one
side. If belt is going toward one side, follow tracking
instructions in step 29. If belt is tracked (centered) correctly,
proceed to walk on the treadmill at 2 mph. If belt feels like it
is slipping under your feet, follow tension instructions in
step 28.
25. When belt tension and tracking are both correct, move to
next step.
8-32x1 (4x) Cross-head Screws
WARNING
Do not plug treadmill into a surge suppressor or
GFI outlet.
