VNG/VLP SERIES PRESSURE WASHER
OPERATOR’S MANUAL
5
CAUTION: Hot discharge fluid. Do
not touch or direct discharge
stream at persons.
9.
Never make adjustments on
machine while in operation.
WARNING: High pressure can
cause paint chips or other par-
ticles to become airborne and fly
at high speeds.
10. Eye safety devices and foot pro-
tection must be worn when us-
ing this equipment.
WARNING: Risk of asphyxiation.
Use this product in a well venti-
lated area.
11. When the machine is working,
do not cover or place in a closed
space where ventilation is insuf-
ficient.
12. Machines with shut-off spray
gun should not be operated with
the trigger in the off position for
extensive periods of time as this
may cause damage to the
pump.
13. Protect from freezing.
14. Be certain all quick coupler fittings are secured be-
fore using pressure washer.
15. Do not allow acids, caustic, or abrasive fluids to pass
through the pump.
16. Inlet water must be from a cold, fresh city water sup-
ply.
17. To reduce the risk of injury, close supervision is nec-
essary when a machine is used near children. Do
not allow children to operate the pressure washer.
This machine must be attended during opera-
tion.
18. The best insurance against an accident is precau-
tion, and knowledge of the machine.
19. Do not operate this product when fatigued or under
the influence of alcohol or drugs. Keep operating
area clear of all persons.
20. Do not replace LP tank while machine is running.
Serious injury could result.
WARNING: Use vapor fuel only.
21.The VLP models are designed to
run on vapor propane fuel. Do
not use liquid fuel. Have a quali-
fied serviceman install and ser-
vice your equipment.
22. Never expose a spark or flame
where there may be unburned
gas present.
23. L.P. gases are heavier than air and will spill out on
the floor. Therefore always provide adequate space
and ventilation around these machines. Install the
machine 18" above the floor.
24. Landa will not be liable for any changes made to our
standard machines, or any components not pur-
chased from Landa.
25. Do not overreach or stand on unstable support. Keep
good footing and balance at all times.
26. Follow maintenance instructions specified in manual.
27. When making repairs disconnect from electrical
source and shut off gas valve.
28. Turn burner off and cool to 100°F before turning ma-
chine off.
WARNING: If you smell gas, shut
off the gas supply to the appli-
ance.
29. Extinguish any open flame, and
test all joints with a soap solu-
tion. If the odor persists, call
your gas supplier immediately.
30. This machine must be attended
during operation.
31. Not suitable for connection to Type B gas vent if the
stack temperature exceeds 243° C (470° F).
32. A draft hood shall be installed if this machine is go-
ing to be permanently installed and vented to the
outside of the building.
INSTALLATION
Place machine in a convenient location providing ample
support, drainage and room for maintenance.
Location:
This machine is certified for indoor installation. Its
location should protect the machine from damaging
environmental conditions, such as wind, rain and
freezing.
1. The machine should be run on a level surface where
it is not readily influenced by outside sources such
as strong winds, freezing temperatures, rain, etc. The
machine should be located considering accessibil-
ity of the components and the refilling of detergents,
adjustments and maintenance. Normal precautions
WARNING
USE PROTECTIVE
EYEWEAR WHEN
OPERATING
EQUIPMENT.
WARNING
RISK OF
ASPHYXIATION. USE
THIS PRODUCT ONLY
IN A WELL
VENTILATED AREA.
WARNING
RISK OF FIRE OR
EXPLOSION, USE
VAPOR FUEL ONLY.
WARNING
RISK OF EXPLOSION:
IF GAS SMELL IS
PRESENT, TURN OFF
SUPPLY.
HOT DISCHARGE FLUID.
DO NOT TOUCH OR
DIRECT DISCHARGE
STREAM AT PERSONS.
CAUTION
