13
Operations
Operation Instructions
STEP 1:
Turn on water at faucet
and pull trigger on spray gun
allowing water to flow until all air
has discharged from system.
Check for water leaks; tighten as
needed.
STEP 4:
With spray nozzle pointed
away from you or anyone else,
press trigger on spray gun to obtain
pressurized cold water spray.
STEP 5:
For hot water, turn burner
switch ON when a steady stream of
water flows out of the spray gun.
Burner will light automatically.
NOTE:
Do not start machine with
burner switch on.
STEP 2:
Before installing nozzle,
turn on water supply and run
machine allowing water to flush
through the system until clear. Pull
wand coupler collar back and insert
desired pressure nozzle into
coupler then secure by pushing
coupler collar forward.
NOTE:
Variable pressure control
wand handle must be turned
clockwise to enable water to flow
out of the high pressure nozzle.
STEP 3:
Read engine manual, turn
on gas valve and choke. Turn the
engine switch to the START
position and hold it there until the
engine starts.
NOTE:
Do not use the electric
starter for more than five seconds
at a time. If the engine fails to start,
release the switch and wait ten
seconds before operating the
starter again. When the engine
starts, allow the engine switch to
return to the ON position. If the
engine is to be started without the
battery, turn switch to start position
and pull rope to start. Turn off
choke.
WARNING: Starter cord kickback
(rapid retraction) can result in
bodily injury. Kickback will pull
hand and arm toward engine
faster than you can let go.
ALWAYS relieve spray gun
pressure before pulling starter
cord. Pull starter cord slowly
until resistance is felt, then pull
rapidly.
AVERTISSEMENT: Le retour du
cordon de lancement (rétraction
rapide) peut causer des lésions
corporelles. La rétraction rapide
de la corde du démarreur (recul)
attire la main et le bras vers le
moteur plus vite qu'il n'est
possible de lâcher la corde.
Toujours retenir la charge
solidement en place avant de
conduire. Tirer lentement sur le
cordon de lancement jusqu'à ce
qu'une résistance soit sentie,
puis tirer rapidement.
CH
AU
D!
Gas
Valve
Choke
Engine
Switch
Landa MHC 9.800-950.0 - BM
Collar
SenD
EC
TAC
H/HOU
R
1/10
Burner
Switch
Burner
Switch
For:
MHC3-24324
Variable Pressure
Control Handle
Trigger
Variable Pressure
Wand (VP)
High Pressure
Nozzle
Brass
Soap
Nozzle
Selection of high or low pressure is accompanied by turning the handle.
NOTE:
High pressure nozzle must be inserted at end of wand to obtain
high pressure. To apply soap read Detergents and General Operating
Techniques section.
