6
INSTALLATION
INSPECTION AND INSTALLATION
Upon receipt of the oven(s) any damage should be noted on the Bill of Lading and countersigned by the
carrier. If concealed damage is discovered the carrier should be notified. All claims must be filed with
the carrier.
Move the crate(s) containing the oven(s) as close to the place of installation as possible before removing
the protective crating. Uncrate the oven(s) and move them as close as practical to the final installation
site.
Bolt the legs to the bottom oven, (See figure #2). Use the 3/8 – 16 x 5/8 Bolts, Hex Nuts and Washers
provided. There are pre-punched holes provided in the legs and oven bottom to aid in leg installation.
Now the oven can be set upright in or near its final position.
SINGLE OVENS:
Connect power throught the knockout on the bottom of the unit.
The oven can be placed in its final position and leveled. The oven is ready for initial start-up procedures
now. (See page 7)
STACKED OVENS:
Be careful to route the power supply wire
between the two ovens using the holes
provided. Do not pinch or cut the supply wires
when stacking the ovens. Use the stacking kit
provided to secure the top oven to the bottom
oven.
The stacking kit contains four (4) identical
corner braces, one brace goes on each corner.
Drill pilot holes for the mounting screws using
the pre-punched holes as a guide. Secure
the top oven to the bottom oven with the sheet
metal screws provided. (See figure #3)
Connect the power supply leads from the top
oven to the power supply leads of the bottom
oven and incoming power per the wiring
diagram on Page 11 or 12.
Now the bottom oven can be connected
to the incoming power supply through the
knockout provided in the bottom of the oven.
Be sure the power supply voltage matches the
voltage specified on the nameplate located
on the front of the oven! Then the oven can
be placed in its final position and leveled.
The oven is ready for initial start-up procedures
now. See page 7.
IL1321
Nut 3/8 - 16 Hex
Lock Washer
Washer
Oven Bottom
Bolt 3/8 - 16 x 5/8
Flange
Leg
Top Oven
Bottom Oven
Corner Brace
IL1322
Figure 2, Bolting Legs to bottom oven
Figure 3, Securing the top & bottom ovens together.
