2
Manual No. 701-154M
06/25/07
Land Pride
Assembly Instructions
■
2. Place two 1" x 1-1/2" Machine Bushings (#19) on the
Wheel Mount (#17) shaft. Slide the Wheel (#18) on the
Wheel Mount (#17). Slide another two 1" x 1-1/2"
Machine Bushings (#19) on the Wheel Mount (#17)
shaft. Secure the Wheel assembly with one 5/32" x 1-1/
2" Cotter Pin (#20). Repeat this step on the other side.
Note: You may only need to install some of the Machine
Bushings (#19). Only use enough Machine Bushings
(#19) to ensure a snug wheel fit.
Two Machine Bushings (# 18)
Two Machine Bushings (# 18)
3. Place the Pivot Tube (#3) between the front support
rails as shown in the picture above and attach using one
of the 3/8" x 2-1/4" Bolts (#12) and Nylock Locknuts
provided. Tighten fully and then back off turn or just until
the Pivot Tube (#3) can rotate inside the support rails.
4. Install one of the 3/8" 2-1/2" Lock Pins (#8) in the rear
hole of the Pivot Tube (#3) as shown and then attach the
Trailer Tongue (#2) using the remaining 3/8" x 2-1/4" Bolt
(#12) and Nylock Lock Nut. Tightent securely and then
back off turn or just until the railer Tongue (#2) can rotate
side to side.
!
CAUTION
Be aware that the GOUND CLEARANCE of your machine is
reduced. This could result in a loss of control of your machine
and cause injury or death. Do not exceed 5 Mph with the hitch
installed and remove it before trail riding.
Square Nut ALWAYS
goes inside of channel.
Must Pivot At These two Points
Square Nut Always Goes Inside
of Channel
One Flatwasher (#14)
Above The Eyebolt
(#8) & One Below
