Land Pride SPL1060, Operator'S Manual

Page: 10 / 28

Section 1: Options & Accessory Set-up
Table of Contents
SPL1060, SPL1072, & SPL1084 Snow Pusher 303-451M 11/7/18
6
Section 1: Options & Accessory Set-up
Dealer Preparations
Ensure that the intended tractor conforms to the
requirements stated under the heading
“Tractor
Requirements” on this page.
Refer to Figure 1-1:
DANGER
!
To avoid serious injury or death:
•
Keep clear while lifting the Snow Pusher from the crate.
The Snow Pusher is back heavy and can flip suddenly.
•
The Snow Pusher is back heavy and can tip over backward
once unhooked. Always unhook unit on level ground with
support blocks under the skid shoes at the back to tip the
unit forward. Never unhook unit with back of unit facing
downhill.
1. The Snow Pusher is shipped on its back. Cut corner
posts of shipping crate and remove top frame.
2. Attach lifting chains to slots in the side panels.
3. Stabilize unit against flipping by attaching additional
chains to the holes at the front of the side panels.
4. Using a hoist, fork lift, or other lifting device, slowly lift
Snow Pusher until it has rotated upright.
5. Lower Snow Pusher until skid shoes are resting on
support blocks at the back of the unit and on the
ground at the front of the unit to make the unit tip
slightly forward.
Accessories are easier to attach after hooking-up Snow
Pusher to a tractor front loader. Refer to
“Hook-Up Snow
Pusher” on page 10.
Tractor Requirements
The Snow Pusher is designed to attach to tractor loaders
equipped with a universal quick-attach hitch. The
following requirements must be met:
Front loader hitch type . . . . . . . Universal quick-attach
Horsepower range . . . . . . . . . . . . . . . . . . . . 20-45 hp
Maximum tractor weight . . . . . . . . . . . . . . . . 3,000 lbs
Maximum tractor lift capacity at pivot pins . . 1,200 lbs
WARNING
!
To avoid serious injury or death:
•
Lightweight power machines may need weight added to the
rear to maintain steering control and prevent forward
tipping or side tipping caused by a heavy front load. Consult
your power machine Operator’s Manual to determine
proper weight requirements and maximum weight
limitations.
•
Power machines outside the listed horsepower range must
not be used. Higher horsepower machines can damage the
attachment. Under horsepower machines makes the job
more difficult and are easier to tip over when loader arms
are raised due to high center of gravity.
Torque Requirements
Refer to “Torque Values Chart” on page 22 to for
correct torque values when tightening hardware.
Dealer Preparations
Figure 1-1
Support Block
Lifting Slots
Attach 2 lift chains to the front of the side plate
to help keep unit from flipping forward suddenly
while lifting the unit to its upright position.
Support Block
39891