Section 1: Assembly & Set-Up
SGC1060 & SGC1072 Grapples 380-092M
5/18/21
9
Customer Supplied Hydraulic Components
Figure 1-1
Installation of Customer Supplied
Hydraulics
Refer to Figure 1-1:
Hydraulic hoses, adapter fittings, and quick disconnect
couplings for connecting grapple to tractor remote outlets
are not included as they may vary depending upon which
tractor the grapple is attached.
1. Attach adapter fittings and quick disconnect couplers
to one end of both hydraulic hoses and tighten.
(Hydraulic hoses, adapter fittings, and quick
disconnect couplings are customer supplied.)
2. Attach hydraulic hoses to bulk head tees (#1 & #2)
and tighten.
3. Consult your tractor Operator’s Manual to determine
which remote outlet is under pressure when pulling
back on tractor control lever. Attach the hydraulic
hose connected to tee (#2) to the selected remote
outlet. (Opens grapple claw.)
4. Attach hydraulic hose connected to tee (#1) to the
remaining remote outlet. (Closes grapple claw.)
35665
To Rod End of Cylinder
To Base of Cylinder
3/4" MJIC Threads
NOTE:
Make sure customer supplied hoses and
fittings will connect to 3/4" MJIC threaded ends of
tees (#1 & #2).
NOTE:
Line (#1) leads to rod end of hydraulic
cylinders and will open grapple claw when under
pressure. Line (#2) leads to base end of hydraulic
cylinders and will close grapple claw when under
pressure.
