Important Safety Information
7/17/24
2
Listed below are common practices that may or may not be applicable to the products
described in this manual.
Tire Safety
Tire changing
can be
dangerous
and must be
performed by
trained personnel using the
correct tools and equipment.
Always properly match the wheel
size to the properly sized tire.
Always maintain correct tire
pressure. Do not inflate tires
above recommended pressures
shown in the Operator’s Manual.
When inflating tires, use a clip-on
chuck and extension hose long
enough to allow you to stand to
one side and NOT in front of or
over the tire assembly. Use a
safety cage if available.
Securely support the attachment
when changing a wheel.
When removing and installing
wheels, use wheel handling
equipment adequate for the
weight involved.
Make sure wheel bolts have been
tightened to the specified torque.
Towing Safely
Comply with federal, state, and
local laws.
Use towing vehicle and trailer of
adequate size and capacity. Secure
equipment towed on a trailer with
chocks, tie downs, and chains.
IMPORTANT:
Do not tow a load
that is more than double the weight
of the vehicle towing the load.
Sudden braking can cause a towed
trailer to swerve unexpectedly.
Reduce speed if trailer is not
equipped with brakes.
Transport Safely
Comply with federal, state, and
local laws.
Avoid contact with any overhead
utility lines or electrically charged
conductors.
Always drive with attachment on the
end of the loader arms low to the
ground.
Follow recommendations in the
power machine Operator’s Manual
when driving uphill or downhill and
when parking on an incline.
Engage park brake when stopped
on an incline.
Never travel at a speed which does
not allow adequate control of the
load, steering, and stopping. Some
rough terrains require a slower
speed.
Practice Safe Maintenance
Understand procedure before doing
work. Refer to the Operator’s Manual
for additional information.
Work on a level surface in a clean,
dry area that is well-lit.
Lower attachment to the ground and
follow all shutdown procedures
before leaving the operator’s seat to
perform maintenance.
Do not work under any hydraulically
supported equipment. It can settle,
suddenly leak down, or be lowered
accidentally. If it is necessary to work
under the equipment, securely
support it with stands or suitable
blocking beforehand.
Use properly grounded electrical
outlets and tools.
Use correct tools and equipment for
the job that are in good condition.
Allow equipment to cool before
working on it.
Disconnect battery ground cable (-)
before servicing or adjusting
electrical systems or before welding
on equipment.
Inspect all parts. Make certain that
parts are in good condition &
installed properly.
Replace parts on this attachment
with genuine Land Pride parts only.
Do not alter this attachment in a way
which will adversely affect its
performance.
Do not grease or oil attachment
while it is in operation.
Remove buildup of grease, oil, or
debris.
Always make sure any material and
waste products from the repair and
maintenance of the attachment are
properly collected and disposed of.
Remove all tools and unused parts
before operation.
Dig Safe - Avoid
Underground Utilities
USA: Call 811
CAN:
http://www.clickbeforeyoudig.com
Always contact your local utility
companies (electrical, telephone,
gas, water, sewer, and others)
before digging so that they may
mark the location of any
underground services in the area.
Be sure to ask how close you can
work to the marks they positioned.