Section 2: Set-Up of Accessories
11/27/18
15
Skid Shoe
Kit Bundle
(Pair of skid shoes)
301-110A . . . . . . . . . . . . . . . . . SKID SHOE ASSEMBLY
The skid shoes are attached at both ends of the blade to
help protect from damaging the ground/paved surface.
1.
Attach skid shoe mount (#4) with two 1/2"-13 x 4 1/2"
GR5 hex head cap screw (#1), flat washers (#8),
spring lock washers (#6), and hex nuts (#7). Tighten
hardware to the correct torque.
2. Insert skid shoe (#3) into skid shoe mount (#4).
Secure with clevis pin (#2) and hair pin cotter (#5).
3. Repeat steps 1 & 2 for the other side.
Skid Shoe Assembly
Figure 2-7
End Plates
Kit Bundle (Pair of End Plates)
301-147A . . . . . . . . . . . . . . . . . . . . . . . . . END PLATES
End plates are attached to both ends of the blade to help
eliminate spillage when moving snow or loose material.
1.
Attach right-hand end plate (#3) to the moldboard as
shown with two 5/8"-11 x 2" GR5 hex head cap
screws (#4), spring lock washer (#7), and hex nuts
(#8). Draw hex nuts up snug. Do not tighten.
2. Attach side plate support strap (#2) with two 1/2"-13
x 1 1/4" GR5 hex head cap screws (#1), lock washers
(#5), and hex nuts (#6). Draw hex nuts up snug. Do
not tighten.
12549
NOTE:
Alternate tightening of bolts when installing
mounting hardware. Some deflection may occur in
moldboard.
3. First tighten hex nuts (#8) to the correct torque and
then next nuts (#6) last.
4. Repeat steps 1-3 for the left-hand end plate.
.
End Plate Assembly
Figure 2-8
Wear Edge Plates
Kit Bundle
301-148A . . . . . . . . HARDENED WEAR PLATES (PAIR)
Hardened wear plates are attached to both ends of the
blade. These plates are designed to protect moldboard
edges when blade is used for digging ditches or working
abrasive material.
1.
Attach wear plate (#2) to the moldboard with
5/8"-11 x 2" GR52 round head square neck bolt (#1),
lock washer (#3) and hex nut (#4). Tighten hardware
to correct torque.
2. Repeat step 1 for the left-hand wear plate.
Wear Plate Assembly
Figure 2-9
12550
12909
