Section 2: Set-Up of Accessories
1/13/21
16
Hydraulic Cushion Valve Assembly
Figure 2-3
24997
Customer to supply Quick
Disconnect Couplings.
Blade Ange Cylinder
Blade Offset Cylinder
Hydraulic Cushion Valve
Kit Bundles
301-235A . . . . . . . . . 96" - CYLINDER CUSHION VALVE
301-234A . . . . . . . . 108" - CYLINDER CUSHION VALVE
CAUTION
!
To avoid minor or moderate injury:
Do not operate Rear Blade with angling or offset cylinder fully
extended. Fully extending either cylinder will keep cushion
valves from operating correctly.
Refer to Figure 2-3:
1. Mount cushion valves (#1 & #2) onto mounting plate
with 3/8"-16 x 4" GR5 hex head cap screws (#3),
spring lock washers (#4) and hex nuts (#5). Tighten
hex nuts to correct torque.
2. Screw eight fittings (#6) into cushion valves (#1 & #2)
until tight.
3. Attach hydraulic hose (#7) to the right rear fitting of
cushion valve (#2) as shown.
4. Attach hydraulic hose (#8) to the right front fitting of
cushion valve (#1) as shown.
5. Attach hydraulic hose (#9) to the left rear fitting of
cushion valve (#1) as shown.
6. Attach hydraulic hose (#10) to the left front fitting of
cushion valve (#2) as shown.
7. Attach four hydraulic hoses (#11) included with this
option to the remaining cushion valve fittings (#6) and
thread through the hose retainer (#12).
