Section 2: Set-Up of Options
11/27/18
12
2. Select two 90 degree elbows (#5) and install them
into the cylinder ports as shown. Tighten as needed.
3. Screw 129" long hydraulic hoses (#6) into the
elbows (#5) and tighten.
4. Thread adapter fittings (#7) to the other end of the
hydraulic hoses and tighten. (Customer to supply
quick disconnect hydraulic couplings.)
5. Attach hydraulic cylinder (#3) to the lugs at the back
of the blade with clevis pins (#1). Make sure hydraulic
ports are positioned on the back and the cylinder
base is mounted to the center lug as shown.
6. Secure clevis pins with hair pin cotters (#2).
7.
Route hoses through hose brackets located on the
main frame and hitch. Connect hoses to tractor's
hydraulic system.
8. Remove shipping block at this time.
Blade Tilting Hydraulic Cylinder Assembly
Figure 2-3
25534
SHIPPING BLOCK
DO NOT REMOVE UNTIL AFTER ALL
HYDRAULIC CYLINDERS AND/OR
RATCHET JACK AND MANUAL LINKS
HAVE BEEN INSTALLED.
Customer to supply
Quick Disconnect
Couplings.
Blade Tilt Cylinder
Refer to Figure 2-3:
WARNING
!
To avoid serious injury or death:
Do not remove shipping block from blade tilt housing until
after all manual links, ratchet jack, and/or hydraulic cylinders
have been installed and cylinders have been charged with oil.
1.
Position hydraulic cylinder (#3) with ports on top as
shown. Place orifice (#4) in the port hole at the rod
end of cylinder. B
IMPORTANT:
Attach cylinder base to the upper
cylinder mount. The base will interfere with the
moldboard if attached to the lower cylinder mount.
