Land Pride RCP2760, Operator'S Manual

Page: 60 / 78

Section 6: Hydraulic Plumbing
Table of Contents
3/12/21 RCP(M)2760 & RCP(M)3760 Parallel Arm Rotary Cutter 316-548M
56
Deck Motor Plumbing
Refer to Figure 6-3:
The hydraulic motor on the deck is powered by a tractor
driven hydraulic pump receiving fluid from the 40 gallon
reservoir.
If cutter blades stall, an overpressure relief valve opens
to return oil to the reservoir. All return oil is filtered of
particulates before dumping into the reservoir. Case
drain is not filtered. Make certain the hydraulic reservoir
is full of oil and that the shut-off valve is fully open before
engaging tractor power take-off.
Deck Motor Plumbing for Tractor Control Option
Figure 6-3
Shut off
valve
Return line
Pressure line
Case drain line
Relief
valve
40 gallon
reservoir
72899
Motor pump
Deck motor
Independent Control Options
Refer to
“Independent Control Option”
on page 32 for
assembly and set-up instructions.
Cylinder Plumbing
Refer to Figure 6-4:
Make sure ARM1, ARM2, and DECK cylinders are
plumbed to ports (SA, SB, SC, SD, SE, and SF). The
BREAKAWAY cylinder is plumbed to ports (BB and BR)
at the valve control box.
Hydraulic Cylinder Plumbing for Independent Control Option
Figure 6-4
72946
Valve
control
box