Land Pride RCM4715, Operator'S Manual

Page: 63 / 72

Section 5: Maintenance & Lubrication
RC(M)4715 & RCG(M)4715 Rotary Cutters 334-113M 6/3/20
59
Table of Contents
Lubrication Through Three Holes In Driveline Shield
Figure 5-21
Accessing CV Driveline Joints
Refer to “CV Driveline Joint Access” on page 58
There are two ways the constant velocity driveline joints
shown in Figure 5-21 can be accessed for lubrication.
One is through holes in the driveline shield and the other
is to slide the shields back to expose the grease zerks as
shown in Figure 5-25.
Lubrication Through Access Holes
1.
Refer to Figure 5-21:
Rotate driveline shield until
holes in shield align with grease zerks in CV joint.
2. Apply correct type and amount of lubrication. Refer to
“CV Main Driveline Joints” on page 58 for
quantities and type of lubrication.
3. Refer to Figure 5-22: Rotate driveline shield 180
o
until holes on opposite side of shield aligns with
remaining grease zerks in CV joint.
4. Repeat step 2 above on any grease zerks that were
not greased in step 2.
5. Steps 1-2 can be repeated to lubricate universal joint
on opposite end of driveline. (Opposite end of
driveline has only one grease zerk.)
Lubrication By Sliding Driveline Shields Back
1.
Refer to Figure 5-23:
With a flathead screwdriver or
similar tool, pry top of red locking tab up.
2.
Refer to Figure 5-24:
Rotate white locking ring
counterclockwise to the position shown.
3.
Refer to Figure 5-25:
Pull back on driveline shielding
until CV joint is exposed.
4. Apply correct type and amount of lubrication. Refer to
“CV Main Driveline Joints” on page 58 for
quantities and type of lubrication.
5. Slide driveline shield back to its operating position.
6.
Refer to Figure 5-23:
Rotate white locking ring
clockwise and press locking tab down until it snaps in
place as shown.
Steps 1-6 can be repeated to lubricate universal joint on
opposite end of driveline.
Rotate Driveline Shield to Align
3-Holes in Shield With Grease Zerks
33992
Lubrication Through Two Holes In Driveline Shield
Figure 5-22
Locked Driveline Shield
Figure 5-23
Unlocked Driveline Shield
Figure 5-24
Slide Driveline Shield Back To Expose Grease Zerks
Figure 5-25
Rotate Driveline Shield to Align
2-Holes in Shield With Grease Zerks
33993
Red Locking Tab
Snapped Down
Into Position
White Locking Ring
Positioned On Right Side
of Red Locking Tab
33994
Red Locking Tab
Pried Up
White Locking Ring
Rotated Counterclockwise
33995
Driveline Shield
Pulled Back
Exposed CV Grease Zerks
33966