Land Pride RCM4715, Operator'S Manual

Page: 25 / 72

Section 1: Assembly & Set-up
RC(M)4715 & RCG(M)4715 Rotary Cutters 334-113M 6/3/20
21
Table of Contents
Fold Lock Lugs Set-up
Refer to Figure 1-18:
If your cutter comes equipped with a dual-action fold
cylinder set up, the fold lock lug plates (#5) do not need to
be flipped around. See
Figure 1-19
.
If your cutter comes equipped with single-action fold
cylinder set up, perform the following steps to flip the four
fold lug plates around. See
Figure 1-20
.
1. With the wings down and on a level surface, remove
all 5/8" hex nuts (#1), lock washers (#2), flat washers
(#3) and 5/8"-11x1 3/4" bolts (#4) from both wing
decks. Set hardware aside for re-use.
2. On both wing decks, flip the fold lock lugs (#5) length
wise as shown.
3. Re-install 5/8" hex nuts (#1), lock washers (#2), flat
washers (#3) and 5/8"-11x1 3/4" bolts (#4). Hand
tighten nuts (#1).
4. Once all hardware has been reinstalled, start the
tractor, and raise the wings. Then shutdown the
tractor without relieving hydraulics.
5. Insert transport pins as shown in Figure 1-16 on
page 20
.
6. Tighten all nuts (#1) on left and right hand wing decks
to correct torque. Refer to
“Torque Values Chart for
Common Bolt Sizes” on page 65 .
Fold Lock Lugs Set-up For Dual-Acting Cylinders
Figure 1-19
Fold Lock Lugs Set-up For Single-Acting Cylinders
Figure 1-20
70545
Tapered
End
70546
Tapered
End
Fold Lock Lugs
Figure 1-18
70544