Land Pride RCM3620, Operator'S Manual, Page: 48 / 64

Section 5: Maintenance & Lubrication
RC3620 & RCM3620 Rotary Cuters 330-841M 9/25/18
44
Table of Contents
Type A Clutch Assembly
Figure 5-8
Clutch Disassembly, Inspection & Assembly
Refer to Figure 5-8:
If clutch run-in procedure above indicated that one or more
friction disks did not slip, then the clutch must be
disassembled to separate the friction disks.
Disassembly
1. Removing spring retainer nuts (#1), springs (#2), and
bolts (#3).
2. Separate disk (#4) from metal surfaces adjacent to
them.
Inspection
Inspect all parts for excessive wear and condition. Clean
all parts that do not require replacement.The original
friction disk thickness is 1/8" (3.2mm) and should be
replaced if thickness falls below 3/64" (1.1mm). If
clutches have been slipped to the point of “smoking”, the
friction disks may be damaged and should be replaced.
Heat build-up may also affect the yoke joints.
Assembly
1. Reassemble each friction disk (#4) next to the metal
plate it was separated from.
2. Install bolts (#3) through end plates and intermediate
plates as shown.
3. Place springs (#2) over the bolts and secure with
nuts (#1).
Refer to Figure 5-9:
4. Progressively tighten each spring retainer bolt until
correct spring height “A” is reached.
14714
IMPORTANT: Keep
track of order and orientation of
your clutch components during disassembly
IMPORTANT: Not all clutches are assembled the
same with the same number of components. Be
sure to keep track of order and orientation of your
clutch components during disassembly.
Type A Clutch Adjustment
Figure 5-9
Driveline
No.
Driveline
Location
power
take-off
Speed
Cat
No. A (inches)
Spring Height
826-494C Wings 540/1000 5 1.32"
826-495C Center 540/1000 5 1.32"
24600