Section 1: Assembly & Set-Up
RCF3096, RCF3010, & RCFM3010 Rotary Cutters 326-566M
22
11/8/18
RCF3096 Semi-Mount Tailwheel Assembles
Figure 1-15
35048
RCF3096 Model With 15" Tailwheel Assembly
35049
RCF3096 Model With 21" Tailwheel Assembly
RCF3096 Tailwheel Assembly
1.
There are several cylinder mounting lugs (#5) that
can be installed on axle (#1). Refer to
NOTES IN
BOLD
in Figure 1-15 to make sure your cutter is
equipped with the correct mounting lug and that the
notch in the lug is located on the axle properly. See
your nearest Land Pride dealer if it is not correct.
2. Install washers (#4) as follows:
RCF3096 With 15" Tailwheels
•
Install two 2 1/4" O.D. machine washers (#4) onto
each tailwheel spindle (#3).
RCF3096 With 21" Tailwheels
•
Install one special 4" O.D. harden washer (#4) onto
each tailwheel spindle (#3).
NOTE:
If preferred, rear guards may be assembled
before the tailwheels. See
“Assembly of Optional
Equipment”
on page 34 for rear guard instructions.
3. Insert tailwheel spindle (#3) into pivot tube on end of
tailwheel arm (#2).
4. Install 2 1/4" O.D. machine washers (#5) over each
tailwheel spindle (#3) and secure with 3/8" x 2 1/2" roll
pins (#6).
5. tailwheel arms (#2) should be adjusted to customer
preference. When completed, they should be equal
distance from center line of hydraulic lift cylinder.
a. Loosen hex flange locknuts (#8) and adjust
tailwheel arms (#2) in or out to desired locations.
b. Tighten locknuts (#8) to the correct torque.
6. Continue with
