Land Pride RC5710, Operator'S Manual

Page: 29 / 82

Section 1: Assembly & Set-up
RC(M)5710 & RC(M)L5710 Rotary Cutters 331-433M 6/3/20
25
Table of Contents
Fold Lock Lugs Set-up
If the cutter is setup with a
Dual-Action Folding
Cylinder and folding lock lug (#5) are arranged as shown
in Figure 1-20, then the lugs must be flipped around to be
like Figure 1-21. Follow steps 1-7 below to flip the lugs
around.
If the cutter is setup with a
Single-Action Folding
Cylinder and folding lock lugs (#5) are arranged as
shown in Figure 1-21, then the lugs must be flipped
around to be like Figure 1-20. Follow steps 1-7 below to
flip the lugs around.
Refer to Figure 1-19:
1. With the wing unfolded on a level surface, remove all
nuts (#1), lock washers (#2), flat washers (#3),
bolts (#4), and the two folding locking lugs (#5). Set
hardware aside for re-use.
2. On the wing deck, flip folding lock lugs (#5) length
wise to be arranged as noted below.
•
For a single-action cylinder, see Figure 1-20.
•
For a dual-action cylinder, see Figure 1-21.
3. Install locking lugs (#5) with existing 5/8"-11x1 3/4"
GR5 bolts (#4), flat washers (#3), lock washers (#2),
and hex nuts (#1). Hand tighten hex nuts (#1).
4. Once all hardware has been reinstalled, start tractor,
and fold the wing fully up.
5. Without relieving hydraulics, shut tractor down before
dismounting according to “Tractor Shutdown
Procedure”
on page 38.
6. Insert transport pin (#2) as shown in Figure 1-17 on
page 24
.
7. Secure locking lugs (#5) to the wing by tightening all
nuts (#1) to the correct torque.
Fold Lock Lugs (#5) Set-up For Single-Action Cylinder
Figure 1-20
Fold Lock Lugs (#5) Set-up For Dual-Action Cylinder
Figure 1-21
70546
70546
TAPERED
END
70545
TAPERED
END
Fold Lock Lugs
Figure 1-19
73863