34
RC5010 & RC6010 (540 RPM) and RCM5010 & RCM6010 (1000 RPM) Rotary Cutters 318-128M
8/28/08
Land Pride
Section 5: Maintenance & Lubrication
Divider Box
Type of Lubrication: 80-90W EP
Quantity = As required
NOTE: Do not overfill! Cutter should be level when
checking oil. If, for any reason, all oil has been removed
from gearbox, refill to level plug and allow air to bleed up
from lower cavity, then recheck.
14051
8
Hrs
Gearbox
Make sure wings are down. Unscrew top vent plug in
gearbox to remove dipstick. Wipe excess oil from dipstick
and screw it back into the plug hole. Remove dipstick again
and check oil level mark on dipstick. If low, fill through top
plug hole in gearbox with EP90 oil until oil reaches full mark
on dipstick. Reinstall vent plug with dipstick and tighten.
Take your gearbox to a Land Pride dealer if it requires
service.
Type of Lubrication: EP90 Oil
Quantity = Fill until oil reaches full mark on dipstick.
IMPORTANT: Do not overfill! Level cutter and wait
for gearbox oil to cool before checking. An unlevel
cutter or a gearbox with hot oil will not show correct
oil level on the dipstick.
8
Hrs
23563
Intermediate Driveline Joints
Type of Lubrication: Multi-purpose Grease
8
Hrs
23582
IMPORTANT: Your cutter is shipped with the
gearbox vent plug/dipstick installed in the
gearbox. Please see your Land Pride dealer if the
vent plug/dipstick was not included.
Oil Level Plug
Oil Drain Plug
23603
Oil Fill Plug
