Land Pride RC3614, Operator'S Manual

Page: 32 / 66

Section 1: Assembly & Set-up
Table of Contents
RC3614 & RCM3614 Rotary Cutters 330-918M 1/20/21
28
Hook-up LED Lights
Refer to Figure 1-25:
The lead wiring harness (#13) is equipped with a 7-pin
plug for connecting to the tractor’s 7-pin electrical outlet
shown in Figure 1-26.
1. Route lead wire harness (#13) through the front and
rear spring hose loops (#2).
2. Connect plug on lead wire harness (#13) to the
tractor’s 7-pin electrical outlet.
3. It is best to have a second person to verify the lights
are operating. Start tractor and operate lights as
follows:
a. Turn on headlights to verify red lights illuminate.
b. Turn on flasher lights to verify amber lights are
blinking on and off.
Refer to Figure 1-27:
4. If the lights did not operate properly, recheck hook-up
of the enhance module (#9) and wire harnesses
(#8 & #13) as outlined below. Make any necessary
changes and repeat step 3 above.
a. Reference wire harness (#8) leading to the LED
lights on the right-hand side of the cutter. Make
sure connector (#8R), labeled “ENHANCER”, is
connected to the Red wire connector (#9R) on
enhancer module (#9).
a. Reference wire harness (#8) leading to the LED
lights on the left-hand side of the cutter. Make
sure connector (#8L), labeled “ENHANCER”, is
connected to the Yellow wire connector (#9L) on
enhancer module (#9).
b. Make sure lead wire harness (#13) is connected
to connector (#9C) on enhancer module (#9).
c.
Refer to Figure 1-25:
Ensure that the 7-pin plug
on the end of the 15' lead wire harness (#13) is
properly seated in the tractor’s 7-pin electrical
outlet shown in Figure 1-26.
5. Check routing of wire harness (#8) to make sure they
will not be pinched as the arms fold and unfold and
while raising and lowering the cutter height.
Refer to Figure 1-25:
6. Check routing of lead wire harness (#13) to make
sure it pass through the spring hose loop (#2).
7. Secure harness in place with spiral hose wrap (#3). If
needed, add any cable ties to complete the process.
LED Hookup (Standard Clevis Hitch Shown)
Figure 1-25
Tractor 7-Pin Electrical Outlet
Figure 1-26
Enhance Module Wire Connections
Figure 1-27
37906
Pin No. 7
Registration
Plate Light
RH Turn
Single Light
Brake Stop Light
Ground
Tail Light
LH Turn
Single Light
RH Turn
Single Light
37624
72210
Has a Yellow Wire
Has a Red Wire