20
Section 1: Assembly & Set-up
RC2512 Series 2 S/N Rotary Cutters 330-725M
10/7/21
Tractor 7-Pin Electrical Outlet
Figure 1-8
Hook-up LED Lights
Refer to Figure 1-7 on page 18:
The lead wiring harness (#11) is equipped with a 7-way
round pin connector for connecting to the tractor’s 7-pin
electrical outlet shown in Figure 1-8.
1. Route lead wire harness (#11) through spring hose
loops (#10).
2. Connect lead wire harness (#11) to the tractor’s
7-way round pin receiver.
3. It is best to have a second person verify the lights are
operating. Start tractor and operate lights as follows:
a. Turn on head lights to verify red lights illuminate.
b. Turn on flasher lights to verify amber light are
blinking on and off.
Refer to Figure 1-9:
4. If the lights did not operate properly, recheck hook-up
of enhance module (#9) and wire harnesses
(#8 & #11). Make any necessary changes and repeat
step 3.
a. Reference wire harness (#8) leading to the LED
lights on the right-hand side of the cutter. Make
sure connector (#8R), labeled “ENHANCER”, is
connected to the Red wire connector (#9R) on
enhancer module (#9).
a. Reference wire harness (#8) leading to the LED
lights on the left-hand side of the cutter. Make
sure connector (#8L), labeled “ENHANCER”, is
connected to the Yellow wire connector (#9L) on
enhancer module (#9).
b. Make sure lead wire harness (#11) is connected to
connector (#9C) on enhancer module (#9).
c.
Refer to Figure 1-8:
Ensure that the 7-pin plug on
the end of the 15'
lead wire harness (#11) is
properly seated in the tractor’s 7-pin electrical
outlet shown in Figure 1-8.
5. Check routing of wire harness (#8) to make sure they
will not be pinched as the wing deck is folded and
unfolded and while raising and lowering the cutter
height.
Refer to Figure 1-7 on page 18:
6. Check routing of lead wire harness (#11) to make
sure it pass through spring hose loop (#10).
7.
Secure harness in place with cable ties as needed.
Enhance Module Wire Connections
Figure 1-9
72210
11
