Section 1: Assembly & Set-Up
RBT6010 & RBT6012 Rear Blades 301-360M
11/27/18
12
3-Point Hook-Up
DANGER
!
To avoid serious injury or death:
•
Always check all blade hardware for tightness before
moving or working around the unit. Make sure moldboard
pivot and tilt retaining hardware is tightened to the correct
torque. The moldboard can fall from the its pivot mount or
tilt mount if retaining hardware is loose or missing.
•
A crushing hazard exists while hooking-up and unhooking
implement. Keep people and animals away while backing-
up to implement or pulling away from implement. Do not
operate hydraulic controls while a person or animal is
directly behind the power machine or near the implement.
WARNING
!
To avoid serious injury or death:
Always shut tractor down using “Tractor Shutdown
Procedure” provided in this manual before allowing anyone
including the operator to hook-up and unhook implement.
Standard 3-Point Hook-Up
A 3-Point Category II or III hitch is required. The lower
3-Point arms of the 3-Point hitch must be stabilized to
prevent side-to-side movement. Most tractors have sway
blocks or adjustable chains for this purpose.
1.
Shorten or remove tractor drawbar to keep it from
interfering with the Rear Blade.
NOTE:
Land Pride’s Quick Hitch can be attached to
the tractor to provide quick and easy 3-point hook-
up and detachment. See your nearest Land Pride
dealer to purchase a Quick-Hitch.
2. Remove linchpins and hitch pins from clevis
lugs.Keep for reuse.
3. Slowly back tractor up to 3-Way Rear Blade while
using tractor’s 3-Point hydraulic control to align hitch
holes in lower arms with implement’s hitch pin holes.
4. Engage tractor park brake, shut tractor engine off
and remove key before dismounting from tractor or
allowing someone else to hook-up the Rear Blade.
5. With tractor’s lower hitch arms aligned and
positioned in the clevises, insert hitch pins through
the clevis lugs and lower arm hitch holes. Secure
hitch pins with linchpins.
6. Ensure lower arms are stabilized to prevent
excessive side movement.
7.
Remove hitch pin from park stand and rotate stand
fully up. Reinsert hitch pin and secure with hairpin
cotter.
8. Connect top center link to the upper pivot hitch
mounting holes using customer supplied 1" clevis pin
and linchpin. If hooking-up with a Cat. III hitch, a
1.01" I.D. x 1 1/4" O.D. x 2.06" long bushing (supplied
by customer) is also required. Bushing may be
purchased from Land Pride, Part No. 325-096D.
9. Manually adjust one of the two lower lift arms up or
down to level the Rear Blade from left to right.
10. Manually adjust length of the top-link to level the
Rear Blade from front to rear.
3-Point & Quick Hitch Hook-Up
Figure 1-5
37298
27876
Cat. II Lower Hitch Pin
Install 1 7/16" O.D.
bushings when using
Land Pride’s
QH20 Quick Hitch.
Park
Stand
Linchpin
Cat. II & III Top Center
Link Mounting Holes
Hitch Pin
QH20 Quick Hitch
Mounting Holes
Cat. III Lower Hitch Pin
Cat. III Note: Customer To Supply
Top Center Link Bushing. See step 8
for additional information.
