Section 2: Options, Assembly & Set-Up
1/13/21
RBT3584 & RBT3596 Rear Blades 301-251M
16
5. Thread adapter fittings (#5) to other end of hydraulic
hoses and tighten.
6. Thread quick disconnect couplers (#8) to adapter
fittings (#5).
7.
Attach hydraulic cylinder (#3) to the lugs at back of
blade with clevis pins (#1). Make sure hydraulic ports
are positioned pointing back and cylinder base is
attached to the center lug as shown.
8. Secure clevis pins with hair pin cotters (#2).
9. Route hoses through hose brackets located on
mainframe and hitch.
10. Connect hoses (#6 & #7) to tractor's hydraulic system
and charge hydraulic cylinder (#3) with oil.
11. The shipping block can be removed once hydraulic
cylinder (#3) is installed and charged with oil.
Blade Tilting Cylinder (Option)
Refer to Figure 2-3:
WARNING
!
To avoid serious injury or death:
Do not remove shipping block from blade tilt housing until
after all manual links, ratchet jack, and/or hydraulic cylinders
have been installed and cylinders have been charged with oil.
1. Select 90 degree elbow (#9) with a small orifice
opening in one end. Thread this elbow into the port
located at the cylinder rod and tighten.
2. Thread the other 90 degree elbow (#4) into the port
located at the cylinder base and tighten.
3. Screw 129" long hydraulic hose (#7) into elbow (#4)
and tighten.
4. Screw 129" long hydraulic hose (#6) into elbow (#9)
and tighten.
IMPORTANT:
The blade tilt cylinder receives a 90
degree elbow with a small orifice in one end of the
elbow. Make sure this orifice elbow is installed in the
cylinder port at the rod end of the tilt cylinder.
IMPORTANT:
Attach cylinder base to the upper
cylinder mount. The base will interfere with the
moldboard if attached to the lower cylinder mount.
24755
Blade Tilting Hydraulic Cylinder Assembly
Figure 2-3
