![background image](http://html1.mh-extra.com/html/land-pride/ps25120/ps25120_operators-manual_3517626013.webp)
11
Section 1: Assembly & Set-up
4/03/14
PS25120 Primary Seeder 313-156M
4.
Attach one of the hydraulic hoses (#23) to the base
end of 3 1/2" hydraulic cylinder (#19). Attach the
other hydraulic hose (#23) to the rod end of 3 1/4"
hydraulic cylinder (#20). Tighten hoses to elbow
fittings. Do not tighten elbow fittings to the cylinders.
5.
Install 3 1/2" x 8" x 1 1/4" hydraulic cylinder (#19) to
the left side of the seeder with clevis pins (#21) and
secure with hairpins (#22) as shown in Figure 1-6.
6.
Install 3 1/4" x 8" x 1 1/4" hydraulic cylinder (#20) to
the right side of the seeder with clevis pins (#21) and
secure with hairpins (#22).
7.
Route hydraulic hose (#23) on the left side through
split flex hose guard (#10), around frame end plates,
through holes in box support, behind upper hitch,
and along the tongue towards the hitch. Finish by
going through the spring hose loop.
8.
Repeat step 7 for the right side.
9.
Route hydraulic hose (#24) through the holes in the
box supports, around the frame end plates on both
ends, and through the split flex hose guards (#10) to
the cylinders. Any excess hose should be coiled at
the upper hitch and tied with a plastic tie.
10. Attach hydraulic hose (#24) to rod end of hydraulic
cylinder (#19) and to the base end of hydraulic
cylinder (#20) as shown.
11. Adjust angle of elbows (#25) to suit and tighten.
12. Position hose clamps (#28 & #29) as shown and
fasten together with 5/16" carriage bolt (#30) and hex
flange nut (#31). Tighten nut to the correct torque.
13. Secure hoses to tongue using one of the plastic
cable ties provided.
14. Verify all nuts have been tighten to the correct torque.
End Wheel Hydraulic Schematic
Figure 1-7
15258
Wheel Bracket & Wheel Arm Assembly
Figure 1-6
12738