9
Section 2: Assembly & Set-Up (Optional)
6/15/10
PS2096 Series Primary Seeders 313-308M
Table of Contents
Small Seeds Box (S/N )
Small Seeder Box assembly
1.
Remove the eight bolts, lock washers and nuts that
are assembled in the front of the main box. Retain two
bolts, lock washers and nuts and use these to plug the
two holes in the front of the Small Seeds Box.
Refer to Figure 1-6:
2.
Assemble the Small Seeds Box (#1) at the ends with
the four 5/16” bolts (#3), flat washers (#7), lock
washers (#6) and nuts (#5). Do not tighten until
spacers (step 3) are installed.
3.
Align the four box spacers (#2) to the inner holes of the
Small Seeds Box and the main box and assemble the
four longer 5/16” bolts (#4), flat washers (#7), lock
washers (#6) and nuts (#5).
4.
Refer to Figure 1-4. Attach rubber seed tubes to
feeder cups with clamps provided and then into the
small holes in seed drop without clamps. Push rubber
hoses into the seed drop hole to remove any excess
slack.
Small Seeds Box Assembly
Figure 1-3
20587
Rubber seed hoses
clamped to feeder cups
20596
Plug 2 Holes
Insert rubber hoses
into seed drop holes
Small Seeds Tube Assembly
Figure 1-4
Section 2: Assembly & Set-Up (Optional)
