![background image](http://html1.mh-extra.com/html/land-pride/ps1548/ps1548_operators-manual_3530302008.webp)
6
Section 1: Assembly and Set-up
PS1548 & PS1572 Primary Seeder 313-164M
7/22/05
Land Pride
Table of Contents
Section 1:
Assembly and Set-up
Pre-Assembly Checklist
Sling Bracket
Refer to Figure 1-1:
The sling brackets allow points at each end to hook the
chain for lifting of the unit.When hooking the chain to the
sling brackets, be certain to either use a spreader bar on
the chain or use a long chain to prevent bending the sling
brackets.
Sling Brackets
Figure 1-1
Check
Reference
All major frame components
Operator’s
Manual
Fasteners and pins that were
shipped with the seeder.
NOTE: All hardware from the
factory has been installed in the
location where it will be used. If a
part or fastener is temporarily
removed for assembly reasons,
remember where it goes.Keep the
parts separated.
Operator’s
Manual
All working parts are moving freely,
bolts are tight and cotter pins are
spread.
Operator’s
Manual
If a pin, bolt or other part has been
removed, and you are unsure
where it is used, use the parts
section of this manual to identify it.
Be sure the part gets used in the
correct location. By double
checking while you assemble, you
will lessen the chance of using a
bolt incorrectly that may be needed
later.
Operator’s
Manual
All grease fittings are in place and
lubricated.
Section 5
Page 20
Proper tension and alignment on all
drive chains.
Operator’s
Manual
Safety decals are correctly located
and legible. Replace if damaged.
Important
Safety
Information
21492