Land Pride OS1548, Operator'S Manual

Page: 54 / 66

Section 4: Maintenance & Lubrication
Table of Contents
OS1548 and OS1572 Overseeder (S/N ) 308-303M 11/28/18
50
Long-Term Storage
Clean, inspect, service, and make necessary repairs to
the seeder when storing it for long periods and when
storing it at the end of a working season. This will help
ensure the seeder is ready for field use the next time you
hook-up to it.
1. Completely clean the seedbox of seed and other
debris before storing.
2. Remove any dirt and grease that may have
accumulated on the seeder and moving parts.
Scrape off compacted dirt and then wash surface
thoroughly with a garden hose. A coating of oil may
also be applied to the lower area to minimize
oxidation.
3. Lubricate and adjust all roller chains and fittings.
4. Drain and refill gear case and chaincase oil.
•
Drain oil in gear case by removing plug from the
bottom side of the rotor housing.
•
Drain oil in chaincase by removing oil level plug
and fill plug.
5. Feed cup drive sprocket hub should be oiled in its
square bore. Squirt oil on to the square feed cup
shaft and move feed cup adjustment lever back and
forth to get oil back into the square bore. This is most
important before putting the Overseeder in storage.
6. Check knives for wear and replace if necessary.
7. Inspect Overseeder for loose, damaged, or worn
parts and adjust or replace as needed.
8. Repaint parts where paint is worn or scratched to
prevent rust. Ask your Land Pride dealer for aerosol
touch-up paint. Paint is also available in touch-up
bottles with brush, quarts, and gallon sizes by adding
TU, QT, or GL to the end of the aerosol part number.
9. Replace all damaged or missing decals.
10. Lubricate as noted in “Lubrication Points” starting
on page 50.
11. Store Overseeder and its attachments inside if
possible to extend the Overseeder’s life.
12. When in storage, lower Overseeder with rollers on a
board or hard surface and adjust park stand to
properly support the seeder.
Land Pride Touch-up Paint
Part No. Part Description
821-011C PAINT LP BEIGE SPRAY CAN
821-066C PAINT ORANGE SPRAY CAN
821-070C PAINT GP GLOSS BLACK SPRAY CAN
Lubrication Points
50
Hrs
Multi-purpose
spray lube Multi-purpose
grease lube Multi-purpose
oil lube Intervals in hours at which
lubrication is required
Lubrication
Legend
14191
14191
Power Take-Off - U-Joint
Type of Lubricant: Multi-purpose Grease
Power Take-Off - Profiles
Type of Lubricant: Multi-purpose Grease
10
Hours
20
Hours