![background image](http://html1.mh-extra.com/html/land-pride/nts2507/nts2507_operators-manual_3520765017.webp)
13
Section 1: Assembly & Set-up
NTS2507, NTS2509, & NTS2511 No-Till Seeder 313-629M
3/6/18
5.
Unscrew greasable pivot bolt (#7) and remove
all seed drive sprocket with lockout clutch (#5). Keep
greasable pivot bolt (#7) inserted in drive sprocket.
6.
Slide snap-on actuator (#9) over hub of lockout
sprocket (#5).
7.
Attach sprocket and actuator assembly (#5 & #9) to
bracket “B” with pivot bolt (#7). Tighten 5/8"-11 GR8
pivot bolt (#7) to the correct torque.
8.
Attach Counter Pickup (#3) to pickup mount (#8) with
8-32 x 1 1/2" round head screws (#12) and flat
washer (#23).
9.
Secure screws (#12) with flat washer (#23), lock
washers (#22), and hex nuts (#17). Draw nuts up
snug, do not tighten at this time.
10. Attach ground cable eyelet “C” to back side of
mount (#8) with 8-32 x 1/2" round head screw (#11),
flat washer (#23), lock washer (#22), and nut (#17).
Tighten hex nut to the correct torque.
11. Attach mount (#8) to the back side of bracket “A” by
inserting 1/4"-20 x 3/4" GR 5 bolts (#14) through
bracket “A”, mount (#8), lock washers (#19) and hex
nuts (#16). Tighten hex nuts to the correct torque.
12. Adjust counter pickup to be 1/8" above the highest
surface on snap-on actuator (#9) and tighten nuts
(#17) to the correct torque.
13. Attach console (#1) to the seedbox side panel with
8-32 x 1" round head screws (#13), flat washers
(#23), lock washer (#22), and hex nuts (#17). Tighten
Acremeter Option Assembly
Figure 1-8
39035
hex nuts to the correct torque.
14. Install roller chain (#27) to drive sprocket (#4) and
all-seeds drive sprocket (#5).
15. Adjust idler sprocket (#2) to adjust chain take-up and
tighten nut (#18) to the correct torque.
16. Install roller chain (#28) on all-seeds drive
sprocket (#5) and driven sprocket (#29).
17. Adjust idler sprocket (#24) to adjust chain take-up and
tighten nut (#18) to the correct torque.
18. Run cable ends D&E through zip ties (#10)
(3 locations) making sure wiring is clear of chains,
sprockets, and possible pinch points.
19. Connect cable ends D&E together.
20. Make any necessary adjustments to the cable layout
and then tighten zip ties (#10).
21. For detailed instructions, refer to the included
Acremeter instruction sheet.
22. Secure electrical cables “C”. “D” & “E” to pickup mount
(#8) with cable ties (#10). A third cable tie is available
for securing the wiring away from sprockets and roller
chains.
23. Attach lower guard (#6) with bolts (#15) and flat
washers (#21). Tighten bolts to the correct torque.
24. Attach upper guard (#26) with hand knobs (#25),
bolt (#15), lock washer (#21), and flat washer (#20).
Tighten bolt (#15) to the correct torque. Hand tighten
knobs.