Section 1: Assembly & Set-up
MP10 & MP20 Moldboard Plows 307-244M
10/29/18
11
13. Return to the tractor. Slowly operate 3-point hydraulic
control lever to raise and lower the plow while
checking for clearance between tractor tires, and
plow. Tractor drawbar should have already been
removed in step 2.
14. Shut tractor down according to
15. If needed, make any additional adjustments to the
tractor and plow before continuing.
16. Leveling the plow must be done in the field. See
Unhook 3-Point Plow
Refer to Figure 1-4 on page 10:
DANGER
!
To avoid serious injury or death:
Always secure equipment with solid, non-concrete supports
before working under it. Never go under equipment supported
by concrete blocks or hydraulics. Concrete can break,
hydraulic lines can burst, and/or hydraulic controls can be
actuated even when power to hydraulics is off.
1.
See
plow for long periods and at the end of the season.
2. Park tractor with plow on a flat, level, solid surface.
3. Lower plow down until plow shears are a couple
inches off the ground.
4. Shut tractor down according to
5. Skip to step 8 if unhooking the MP20 plow.
Otherwise, continue with step 6 below.
6. Remove wire retaining pin (#6) from park jack
mount (#7) and rotate park jack (#5) down.
7.
Secure park jack (#5) by inserting wire retaining
pin (#6) in front holes of park jack mount (#7). Make
sure wire retainer is caught over end of pin.
8. Shut tractor down according to
9. Remove customer supplied hairpin cotter (#4) and
clevis pin (#3).
10. Store top center 3-point link in tractor holder.
11. Reinstall clevis pin (#3) and hairpin cotter (#4) in
upper clevis hitch for safe keeping.
12. Remove customer supplied linchpins (#2) and slide
lower 3-point arms off of hitch pins (#1).
13. Replace linchpins (#2) in hitch pins (#1) for safe
keeping.
14. Return to the tractor and drive slowly away making
sure the tractor and 3-point arms are clear while
pulling away.
