Land Pride LR16 Series, Operator'S Manual, Page: 17 / 30

Section 2: Accessory Equipment Set-up
Table of Contents
LR1660, LR1672, LR1684 & LR1696, LR2684 & LR2696 Landscape Rakes 302-305M 11/27/18
13
Grader Blade Set-up without Gauge Wheels
Refer to Figure 2-4:
1. Attach blade support arm (#3) to the right-hand side
of rake mount (#4) with six 3/8" x 2 3/4" GR5 hex
head cap screws (#7), interior/exterior toothed lock
washers (#12), and hex nuts (#8). Tighten to the
correct torque.
2. Attach blade lock handle (#1) to blade support arm
with 1/2" x 3" GR5 hex bolt (#5), lock washer (#11),
and hex nut (#9) as shown. Tighten to proper torque.
3. Insert bent pin (#13) through top hole in blade
support arm (#3). Secure with hairpin cotter (#14).
4. Repeat steps 1-3 to attach blade support arm (#3) to
the left-hand side of rake.
5. Attach right and left end of grader blade (#2) to blade
support arms (#3) with 3/4" x 2 1/2" GR5 hex head
cap screws (#6) and locknuts (#10). Draw locknuts
up snug, do not tighten.
6. Refer to “Side Plate Assembly to Grader Blade”
below for attaching side plates to both ends of grader
blade.
Side Plate Assembly to Grader Blade
Refer to Figure 2-5:
1. Attach two long hex coupler nuts (#5) and flat
washers (#7) to side plate (#1) by inserting 7/16" x 1"
GR5 hex cap screws (#4) complete with lock washers
(#6), and flat washers (#7) through bottom and top
slots of side plate as shown. Draw cap screws up
snug, do not torque tight until step 3.
2. Attach right-hand side plate (#1) to the right-hand
side of grader blade by inserting pivot pin (#2)
through mounting tube (#3). Make certain coupler
nuts (#5) are positioned behind the grader blade.
3. Secure pivot pin (#2) with hairpin cotter (#8)
4. Adjust hex coupler nuts (#5) against back side of
grader blade and tighten hex cap screws (#4) to
proper torque.
5. Repeat steps 1-4 to attach the left-hand side plate
(#1) to the left-hand side of the grader blade.
NOTE: The gauge wheels are set-in from the end
about 1 1/2" on the 60" & 72" rakes and about 7 1/2"
from the end on the 84" & 96" rakes.
Grader Blade Assembly without Gauge Wheel
Right-Hand Side Shown
Figure 2-4
Side Plate Assembly
Right-Hand Side shown
Figure 2-5
33842
33842