Section 3: Optional Equipment
HRS3025 Hydraulic Reservoir System 316-271M
1/16/20
24
Valve Options
The Hydraulic Reservoir System can be set-up with one
of three different valve arrangements. Because each
arrangement operates a little differently, it is important to
know how they operate and which arrangement is best
for the work at hand. See your nearest Land Pride dealer
should you want to change your valve set-up.
No Valve No Cooler Option
316-250A
No Valve & No Cooler Option
Refer to Figure 3-1:
This arrangement is recommended for snow blowers only
and can over heat from continuous use in warm
temperatures.
This option powers hydraulic motors by turning the power
take-off shaft on and off at the tractor controls. Flow to the
hydraulic motor is one direction only; meaning the motor
cannot be run in reverse. A pressure relief valve is
provided to protect the pump and lines from high
pressures.
This arrangement is not good for operating hydraulic
cylinders as they are bi-directional.
No Valve With Cooler Option
316-281A
No Valve & No Cooler Option
Refer to Figure 3-2:
This option powers hydraulic motors by turning the power
take-off shaft on and off at the tractor controls. Flow to the
hydraulic motor is one direction only meaning the motor
cannot be run in reverse. A pressure relief valve is
provided to protect the pump and lines from high
pressures.
An oil cooler with a temperature switch that turns the
cooler on when oil temperature reaches 140
o
F is
included to protect against overheating.
This arrangement is not good for operating hydraulic
cylinders as they are bi-directional.
No Valve Option Without Cooler
Figure 3-1
No Valve Option With Cooler
Figure 3-2
30389
35621
Section 3: Optional Equipment
