Land Pride GR1525, Operator'S Manual

Page: 16 / 44

Section 1: Assembly & Set-up
GR1525 Stump Grinder 328-167M 3/17/20
12
Table of Contents
Tractor Shutdown Procedure
The following are basic tractor shutdown procedures.
Follow these procedures and any additional shutdown
procedures provided in your tractor Operator’s Manual
before leaving the operator’s seat.
1. Reduce engine speed and disengage power take-off
if engaged.
2. Park tractor and implement on level, solid ground.
3. Lower implement to ground or onto non-concrete
support blocks.
4. Put tractor in park or set park brake, turn off engine,
and remove switch key to prevent unauthorized
starting.
5. Relieve all hydraulic pressure to auxiliary hydraulic
lines.
6. If wire harness is included, toggle its rocker switch to
“SWING” position or disconnect the harness from the
solenoid valve.
7. Wait for all components to come to a complete stop
before leaving the operator’s seat.
8. Use steps, grab-handles and anti-slip surfaces when
stepping on and off the tractor.
Driveline Installation
Refer to Figure 1-1:
The driveline is shipped unsecured to the gearbox input
shaft. It must be secured to the gearbox input shaft with
bolts(#6), and nuts (#5). A slip clutch (#7) is provided for
protection from shock loads.
1. To install the driveline, remove 3/8" x 1" bolts (#2),
lock washers (#4), flat washers (#3), and cover (#1).
2. Remove existing nuts (#5), and bolts (#6) from slip-
clutch (#7).
3. Slide splined end of slip clutch (#7) onto the gearbox
input shaft. Make certain that the slip-clutch yoke is
fully onto the shaft splines.
4. Attach slip-clutch yoke to the gearbox input shaft with
removed bolts (#6), and nuts (#5). Tighten nuts (#5)
to the correct torque for a M12 bolt.
5. Push/pull on slip-clutch yoke to ensure it is securely
fastened to the gearbox input shaft.
IMPORTANT:
When shutting down, and if using a
Single Remote Bundle, make sure the control switch
is in the “SWING” position, or disconnect the wire
harness from the solenoid valve to avoid draining the
battery.
IMPORTANT:
The driveline must be lubricated
before putting it into service. Refer to “Lubrication
Points”
on page 33.
Driveline Assembly
Figure 1-1
6. Return cover (#1) and secure in place with
flat washers (#3), lock washers (#4), and
3/8"-16 GR5 bolts (#2). Tighten bolts to the correct
torque.
7. Continue with “Three Point Hook-up” on page 16 or
“Driveline Hook-Up”
on page 17.
Hydraulic Hose Installation
Two optional hydraulic remote bundles are available. One
of the two must be purchased with the Stump Grinder.
The “Single Remote Bundle” is used with tractors
having only one duplex outlet. Use
“Dual Remote Bundle” with tractors having more than
one duplex outlet. Use the following instructions that
match your tractor’s duplex outlets.
Single Remote Bundle
328-155A . . . . . . . . . . . . . . . Single Remote Bundle
Single Remote Valve Assembly
Refer to Figure 1-2 on page 13:
1. Bolt solenoid valve (#15) to mount (#1) with
5/16" x 3 1/4" bolts (#3), lock washers (#6), and
hex nuts (#4). Tighten nuts to the correct torque.
2. Attach valve mount (#1) to the hitch using
3/8" x 1" bolts (#2), lock washers (#7), and
hex nuts (#5).
70282
73634