![background image](http://html.mh-extra.com/html/land-pride/gondo-4400ex/gondo-4400ex_operators-manual_673508025.webp)
6/30/05
23
Section 6: Maintenance
4400EX Heavy Duty Off Road Utility Vehicle 720-051M
Table of Contents
Engine Torques
For engine torque values, see engine owner’s manual.
All Other Torques
For all other torques refer to “Torque Values Chart”
page 45.
Tire Maintenance
Use only tires recommended by Land Pride.
It is important for your safety and the safety of others that
the tires have correct air pressure. Check air pressure in
all four tires before each use. Visually inspect tires for loss
of air throughout each day of operation. See Tire Inflation
Chart below for correct tire pressure.
*
Maximum tire pressure is noted on tire side wall.
Jacking the Vehicle
!
DANGER
For your safety and safety of others, a jacked vehicle must be
supported properly with jack stands before working under and
around it. Also the wheels on the ground must be chocked on
both sides to prevent the vehicle from rolling forward or
backward.
1.
Prepare vehicle for maintenance as outlined in steps
1-6 on page 22.
2.
Loosen the lug nuts on a wheel being removed
approximately 1/2 turn counterclockwise while it is still
on the ground.
3.
See important note above. Place proper jack under
vehicle as follows:
a.
Front tires: Refer to Figure 6-1. Place jack under
the main frame just behind the axle.
b.
Rear tires: Refer to Figure 6-2. Place jack under
the main frame just in front of the axle.
4.
Jack vehicle only high enough to do the work
intended.
5.
Support vehicle securely with jack stands before
working under and around the vehicle.
6.
Work may now be performed on the vehicle. Be sure
to properly torque all bolts that were loosened. Wheel
bolts should be torqued after the vehicle is lowered to
the ground.
7.
Lower the vehicle by first jacking the vehicle up high
enough to remove the jack stands. Then carefully
lower the jack until the vehicle is on the ground.
8.
Remove wheel chocks.
.
Figure 6-1
Figure 6-2
Shock Absorbers
Shock absorbers are located under the seat to make the
ride more comfortable. Traveling fast may cause the shock
absorbers to bottom-out making the ride rough.
Electrical System
A 12 volt, 25 amp, negative ground electrical system is
provided. The electrical system is protected by a fuse
located behind the dash near the key switch and a
moisture proof self-resetting circuit breaker in the wiring
harness near the starter at the engine. The amp ratings
are as follows:
•
Fuse behind the dash - 30 Amps
•
Self-resetting circuit breaker - 30 Amps
Tire Inflation Chart
Tire
Inflation PSI
Front Tires
15
*
Rear Tires
20
*
IMPORTANT: Use a hydraulic jack, floor jack, or
scissor type jack to lift vehicle. Do not use a handyman
jack or bumper jack and don’t jack against the bumper,
body, differential case, axles or hydraulic lines.
21350
21351