Land Pride CB1060, Operator'S Manual

Page: 14 / 32

Section 1: Assembly & Set-up
CB1060 4-In-1 Combination Bucket 381-169M 7/28/22
10
Table of Contents
Land Pride Supplied Hydraulics
Refer to Figure 1-1:
Attach optional “Optional Hose Kit #380-150A” or
“Optional Hose Kit #380-154A”
on page 15 as follows:
1. Attach elbows (#3) to fittings (#1 & #2) on the bucket.
Tighten fittings to elbows (#3) with male ends
horizontal and pointing left as shown.
2. Attach hydraulic hoses (#4) to elbow fittings (#3) and
tighten.
3. Slide coupler end caps (#5) onto hydraulic
hoses (#4).
4. Attach quick connect couplers (#6) to hydraulic
hoses (#4) and tighten.
5. Install one of the
“Optional Third Function Valve
Kits” listed on page 12. Refer to Installation Manual
included with the kit.
NOTE: “Optional Third Function Valve Kits” can
be purchased for installation on most Kubota B and
L Series tractors. These kits allow the operator to
control all bucket movements with a joystick and
provide easy hydraulic hose hook-up at the front of
the loader. See
“Optional Third Function Valve
Kits” on page 14.
NOTE: “Optional Hydraulic Hose Kits”
are also
available to complete the hydraulic connections
between the bucket and quick connect couplers
located at the front of the loader. Refer to “Optional
Hydraulic Hose Kits”
on page 15.
NOTE:
If the above “
Optional Kits”
are not
purchased, the customer will need to supply the
necessary hydraulic components to make the
connection between the bucket and tractor or
loader. Refer to
“Customer supplied Hydraulic
System” on this page.
Customer supplied Hydraulic System
Refer to Figure 1-1:
1. Required hydraulic hoses, hose sleeves, fittings,
couplings, etc. should be determined by customer to
complete fit-up between bucket and tractor or loader.
2. Attach customer supplied hydraulic hose fittings to
the bucket hydraulic fittings (#1 & #2). Tighten
hydraulic hoses to fittings (#1 & #2).
3. Route customer supplied hydraulic hoses in an area
that will not interfere with bucket hook-up. Continue
with
“Hook-up Bucket”
below.
Hook-up Bucket
DANGER
!
To prevent serious injury or death:
A crushing hazard exists when hooking-up and unhooking the
attachment. Do not allow anyone to stand between attachment
and power machine while approaching or backing away from
the attachment. Do not operate hydraulic controls while
someone is near the power machine and/or attachment.
WARNING
!
To prevent serious injury or death:
Check hitch fit-up frequently. An improper fit-up can cause the
attachment to come loose from the loader hitch plate and fall.
NOTE: Customer supplied hydraulic system must
be able to connect to 3/4"-16 MJIC adapter fittings
(#1 & #2).
NOTE:
When under pressure, line (#1) closes the
bucket jaw and line (#2) opens the jaw.
NOTE: This bucket is designed with a universal
quick attach hitch plate on the front mounted loader.
Customer Supplied Hydraulic Components
Figure 1-1
70742