Land Pride CB0550, Operator'S Manual

Page: 15 / 28

Section 1: Assembly & Set-up
CB0550 4-in-1 Combination Bucket 381-139M 2/5/19
11
Table of Contents
Hook-up Without BX Quick Hitch
DANGER
!
To avoid serious injury or death:
A crushing hazard exists while hooking-up and unhooking
implement. Keep people and animals away while backing-up
to implement or pulling away from implement. Do not operate
hydraulic controls while a person or animal is directly behind
the power machine or near the implement.
WARNING
!
To avoid serious injury or death:
Make sure bucket is properly attached to Kubota’s BX front
loader to keep it from coming loose and falling. The center
hitch pin must be properly installed and secured with bolt and
nut. The lower clevis pins must be properly installed and
secured with hairpins.
Extended Hitch Pin Option #380-146A
Figure 1-8
Refer to Figure 1-8:
380-146A Option, BX LOADER DIRECT PIN
Land Pride’s “BX Direct Pin Option” is required when
hooking bucket directly to the front loader arms. See your
nearest Land Pride dealer to order this kit.
35848
Refer to Figure 1-7:
Follow steps 3-7 on this page if hooking bucket directly to
the front loader arms. If hooking bucket to
“Kubota’s
Original Quick Hitch” , see “Hook-up With BX Quick
Hitch” on page 10.
1. Unhook existing attachment from Kubota’s BX front
loader arms. Refer to Kubota Operator’s Manual for
detailed instructions.
2. Store Kubota’s existing lower hitch pins and center
hitch pin with existing attachment.
3. Check for and remove any debris in the hitch point
areas before hooking-up 4-in-1 Combination Bucket.
4. Slowly approach bucket until loader arm hitch holes
are aligned with bucket lower clevis hitch pin holes.
5. Place transmission in park, shut tractor engine off,
remove switch key, and dismount tractor.
6. Pin lower clevises to the front loader lift arms with
extended hitch pins (#1) and secure with hairpin
cotters (#5).
7. Pin upper center clevis to the hydraulic cylinder rod
with hitch pin (#2). Secure hitch pin with hex bolt (#3)
and locknut (#4). Draw locknut up snug; do not
tighten.
8. Refer to Figure 1-9 on page 12: Connect hose
couplers (#6 & #7) to bulk head couplers “A” & “B”. See
“Hydraulic Hose Hook-up” on page 12 for detailed
instructions.
Hook-up Without Kubota’s Original Quick Hitch
Figure 1-7
1
Detail B
35851
35850
Detail A
2
3
4
39629
See Detail A
See Detail B