Land Pride CB0546, Operator'S Manual, Page: 14 / 30

Section 1: Assembly & Set-up
5/24/22 CB0546 4-in-1 Combination Bucket 381-208M
10
Table of Contents
BX Series Kubota Quick Attach Hitch Hook-up
Figure 1-1
Top Angle Bars
Lock Handles
Lock Pins
Bottom Slots
Quick Connect Couplers
76900
Top of Loader
Hitch Plate
Hook-up Combination Bucket
DANGER
!
To avoid serious injury or death:
A crushing hazard exists when hooking-up and unhooking the
attachment. Do not allow anyone to stand between attachment
and power machine while approaching or backing away from
the attachment. Do not operate hydraulic controls while
someone is near the power machine and/or attachment.
WARNING
!
To avoid serious injury or death:
•
Check hitch fit-up frequently. An improper fit-up can cause
the attachment to come loose from the loader hitch plate
and fall.
•
Do not use this attachment to lift the front or back of the
power machine off the ground. Doing so can damage the
attachment, power machine, and/or cause serious injury or
death.
•
Check hitch fit-up frequently to make sure the loader hitch
is properly positioned under the attachment’s top angle
bar(s), and the lock pins are locked fully seated in the
attachment’s bottom slots, An improper fit-up can cause the
equipment to come loose from the loader hitch plate and
fall.
Refer to Figure 1-1:
1. Shut tractor down properly before dismounting. Refer
to
“Tractor Shutdown Procedure”
on page 9.
2. Check for and remove any debris in the hitch areas
before hooking-up to the bucket.
3. Use loader lock handles to raise lock pins on loader
hitch plate.
4. Start tractor and drive slowly to the bucket hitch
making sure that the top of the loader hitch plate is
parallel with the bucket’s top angle bars.
5. Rotate top of loader hitch plate forward and lower
loader arms until top of loader hitch plate is low
enough to fit under the bucket’s top angle bars.
6. Place top of loader hitch plate under the bucket’s top
angled bars. Slowly raise loader hitch plate up until
the hitch plate is seated under the bars.
7. Continue to slowly raise loader arms while rotating
the top of the loader hitch plate back until the bucket
hitch makes full contact with the face of the loader
hitch plate.
8. Shut tractor down properly before dismounting. Refer
to “Tractor Shutdown Procedure” on page 9.
9. Push down on the loader lock handles to drive lock
pins through the bottom slots in the bucket hitch
plate. Make sure lock handles are locked down and
lock pins are fully inserted in the bucket’s bottom
slots.
Hydraulic Hose Hook-Up
WARNING
!
To avoid serious injury or death:
•
Hydraulic fluid under high pressure will penetrate the skin
or eyes causing a serious injury. Wear protective gloves and
safety glasses or goggles when working with hydraulic
systems. Use a piece of cardboard or wood rather than
hands when searching for leaks. If an accident occurs, seek
immediate emergency medical care or gangrene may result.
DO NOT DELAY.